AdjacentFacetsAnglesEveryTolerance
Defines how much (in %) the angle between normals of any neighboring facets can deviate after Smart Recut comparing to Recut.
If at least one of the neighboring facets is girdle or culet, the limitation is not applied. The girdle shape is controlled by the Girdle Shape Tolerance parameters. The culet is not taken into account.
Calculation
The parameter is set manually via preset and control the rule:
A(1+min/100) < B < A(1+max/100)
Where:
- A - the angle between normals of neighboring facets after Recut
- B - the angle between normals of neighboring facets after Smart Recut
- min - a left boundary in preset, should always be negative, for example, "-25"
- max - a right boundary in preset
Usage and Examples
If the parameter set to "-25, 50" and the angle between normals of neighboring facets after Recut (A) is "10°" then:
- 10(1-0.25) < B < 10(1+0.5)
- 7.5 < B < 15
- the angle between normals of the same facets after Smart Recut (B) should be within the interval from 7,5° to 15°.
Reporting
| Reported in | Section | Values | Units | Bookmarks | Name in Reports |
|---|---|---|---|---|---|
None | NA | Single value | % from the initial angle | NA | NA |
Visualization in Appraisers
| Value | Units | Bookmark | Tab | Parameter Name | Comment |
|---|---|---|---|---|---|
| Single value | % from the initial angle | NA | Cut | AdjacentFacetsAnglesEveryTolerance, % | Visible only when presets are displayed. |
AdjacentFacetsAnglesEveryMin
Sets limitation “not less than this value” for the angle between normals of any neighboring facets.
If at least one of the neighboring facets is girdle or culet, the limitation is not applied. The girdle shape is controlled by the Girdle Shape Tolerance parameters. The culet is not taken into account.
Calculation
The parameter is set manually via preset.
Usage and Examples
Should be used to avoid transforming the neighboring facets into a single plane.
The current default values are:
Reporting
| Reported in | Section | Values | Units | Bookmarks | Name in Reports |
|---|---|---|---|---|---|
None | NA | Single value | ° | NA | NA |
Visualization in Appraisers
| Value | Units | Bookmark | Tab | Parameter Name | Comment |
|---|---|---|---|---|---|
| Single value | ° | NA | Cut | AdjacentFacetsAnglesEveryMin | Visible only when presets are displayed. |
0 Comments