Dear Nilesh, Utpal, Janak, Kamal,
Please find new version of Helium Polish version 5.6.73.1,
report.dll version 2.6.6.1, BriRecon.dll 1.1.10.1 and new report
templates here:
Dropbox
(OctoNus)\Download\HP\2015_06_02_HeliumPolish_5.6.73.1.zip
In this version we made the following changes:
1. Error with "Width-wise culet shift ratio" and
"Length-wise culet shift ratio" calculation is fixed. Shift is
calculated for RBC in MAX and MIN diameters directions from now:
2. New report parameter is added - "Girdle center
mass":
2.1 It is calculated as girdle center mass
and indicated on pictures as doted blue cross:
2.2 "Girdle center mass" is used as girdle center for all offset
from now and by default:
2.3 To use old girdle center in offset
calculation please check "Girdle center" check box in Report
options panel:
2.4 Please pay attention that girdle center (blue cross on
pictures same as before) calculation is changed:
2.4.1 For Princess, StepCuts, Radiant, SquareRadiant и
SquareStepCut cuttings it calculates as cross of symmetry axes
(was cross of diagonal axes before).
2.4.2 For Pear
cutting it is cross of symmetry
axis with width axis.
3. There are changes for AnyCut algorithm calculation. Goal
is to improve girdle and crown building for Radiants and
Step-Cuts.
4. New report parameters were added -
CRN_MAIN_5_EDGE_JUNCTION_:
4.1 "Crown main 5 edge junction" is equal
to diameter of minimum circle which includes all 3 nodes at this
junction, in case the triangle build on 3 nodes have angles
below 90°:
4.2 In case if any of angles of triangle build on
3 nodes is above 90°, "Crown main 5 edge junction" (and
circle diameter) is equal to maximum distance between any of the
3 nodes at this junction. Circles are shown in red on pictures
in report:
5. New report parameters were added - STAR_EDGE_:
5.1 On picture below six star edges are
indicated:
5.2 Percentage value is measured as ratio to diameter.
6. New report parameter is added, roundness is
calculated for 22.5° angle from now:
7. All reports templates are updated.
Documentation about report parameters will be created\renewed
shortly. Please let me know if you have any questions.
Best Regards,
Yaroslav Alexandrov