The “19. SmartNormalize” “SmartNormalize” algorithm is intended for the deletion of excess vertices and facets and creating a more symmetrical model from a scanned or Smart Recut model for further optimization or scanning usage .

...

When to use it and what it will give

When to use?

Apply the "19. SmartNormalize" algorithm to a model:

• That you want to register as your in-house cut
• That you want to add as an allocation form to the existing cut

• That you want to use as a sample during scanning
  
  See details on each of these scenarios in the sections below.

  Info
  title Note
  You can also apply the "19. SmartNormalize" algorithm to any model to improve it in the way described below (see "What will it give?")

...

Note that weight as a parameter doesn't participate in optimization by the “19. SmartNormalize” “SmartNormalize” algorithm. So the final solution could be with any weight. It is not important because the purpose of the algorithm is to get the correct model for further work. The results of the “19. SmartNormalize” “SmartNormalize” work cannot be used as cutting plans.

...

The following parameters can be used to configure the “19. SmartNormalize” “SmartNormalize” algorithm behavior and results:

...

Here are some recommendations on how to configure and use the “19. SmartNormalize” “SmartNormalize” algorithm:

1. To improve output, specify facet types for the initial model. This:
   1. will guarantee deleting of excess facets
   2. is necessary for working with enabled Custom Facet Marking parameter (see above)
   3. the facet types are automatically transferred to the resulting model which is useful during registering it as a new in-house cut

2. On Stage 1 (see above) the symmetrical sectors of the model which will in Stage 3 become of the same length, may have large differences in length. Because of this, the different number of girdle facets can go to non-symmetrical sectors. This can lead to poor performance of the Smart Recut algorithm for such models. If this situation occurs, it is recommended to run the Smart Normalize algorithm one more time - it should divide a girdle into facets correctly because initially, the sectors have the same length.

   Before SN
   After 1st run of SN
   After 2nd run of SN

   a

3. The small value of the Shift parameter may block solution search when Custom Facet Marking is enabled.

4. If all the presets produce distorted models, one of the probable reasons is the errors in the detection of symmetry axes or the pairs of symmetrical facets. This may be caused by the large asymmetry of the initial model or the non-standard number of symmetry axes. In this case try specifying facet types, then set SymmetryCoeff to "0" and run Smart Normalize without Symmetry.

5. For square cuts, the algorithm enforces the final GidleRatio to 1.0 to reach the corresponding symmetry.

6. The algorithm can work with the models in which crown and pavilion touch in a vertex or edge. For such cases, the facet types must be specified.

   

7. Nonconvex heart cuts are supported by Smart Normalize and Smart Recut. However, in the case of Hearts, the algorithm more often has difficulties with the girdle shape and finding the correct symmetry axes for the scanned models. Thus for building Heart allocation forms it is better to use the models created in the Cut Designer or the solutions of Recut or Smart Recut algorithms.

...

An Element Multi Selection Tool can be used with the "19. SmartNormalize" algorithm. Using the tool, you can manually select the facets to be mandatorily removed from a model by the "19. SmartNormalize" algorithm. To use the tool, in the Recut mode select your scan or solution in the list, then select the "19. SmartNormalize" algorithm and then on the main panel toolbox, click  > Remove facets by Smart Normalize. This activates the Element Multi Selection Tool; now in the Scene, you can mark facets to be removed by the algorithm with a mouse click. Facets marked for removal are highlighted with red.

...

...