...
There are new parameters for girdle center calculation - Girdle center mass. It is used for offsets calculations from now by default report.dll 2.6.6.1 version by default.
2. Girdle center mass
- Indicated on pictures as doted blue cross (bookmark for this picture is GIRDLE_CENTER_MASS_CROSS):
- Example on picture from report:
- Calculated as center mass of girdle in projection on table plane.
- Used by default for calculation following values:
- Girdle-Culet offset by table axis
- Girdle-Table offset by table axis
- Girdle to table-culet line offset
...