The Print Label report contains reference line parameters:
MeaningAdded to the Print Label report as... | С8 - C8 before | mm | The reference line for the crown main facets before table allowance. | See the detailed description below.
|
---|
С8
|
Marking for Crown - C8 after | mm | The reference line for the crown main facets after table allowance. |
---|
Marking for |
---|
CrownSee description below | Marking for Pavilion | P8 beforePav - P8 after | mm | The reference line for the pavilion main facets before table allowance. |
---|
Marking for Pav - P8 after | mm | The reference line for the pavilion main facets after table allowance. |
---|
Marking for Pav | See description below | C8 bef - C8 after | Table allowance | mm | Table allowance. |
---|
Table polishing, mm | See description below | Table tilt | RotIncline | deg. | Planned table tilt compared to the current table. |
---|
Table polishing, deg. | See description below |
Print Label example:
Image AddedImage Removed
Expand |
---|
|
Info |
---|
This parameter is applicable to the following cuts: Brilliant |
Distance between the holder plane and C8 reference line after table allowance.
Calculation FACETING_REFERENCE_LINE_CROWN_MAINS_AFTER_TABLE = CROWN_HEIGHT_MAX_MM Usage and Examples C8 reference line information is used during polishing. Reporting Reported in | Section | Values | Units | Bookmarks | Name in Reports |
---|
Print Label | NA | Single value | mm | FACETING_REFERENCE_LINE_CROWN_MAINS_AFTER_TABLE | Marking for Crown |
---|
Visualization in Appraisers Value | Units | Bookmark | Tab | Parameter Name | Comment |
---|
NA | NA | NA | NA | NA | Not presented in any appraiser. |
|
...