...
Semi-automatic flat cracks
The new autoplotting algorithm may plot a small percent of real flat cracks and some of flat cracks will be presented in autoplotting results as Auto3D inclusions. For such real flat cracks you may try to automatically convert Auto3D to flat crack.
...
- Run autoplot
- Save results in some temp oxg file (we do it just in case before editing)
- Check plotted flat cracks one-by-one. For convenient iterating through all flat cracks, please sort all inclusions in inclusion panel by Type (desc). At the top of the list you will see all autoplotted flat cracks. If you see a bad flat crack roll back it to 3D inclusion (see chapter "Rolling back the convertion to flat crack") or edit it manually (see "Editing autoplotted flat crack").
NOTE: If the selected inclusion is not a real flat crack you should do roll back. If that is a flat crack and the algorithm calculated bad profile or wrong plane - try to edit crack manually. If that is a flat crack but it is difficult to edit inclusion manually - delete inclusion and build it manually. - Look at all Auto 3D inclusions. If you see some real flat crack, but it was plotted as Auto 3D, try to convert it to flat crack (see "See semi-automatic flat cracks"). If there is no option "Convert to simple flat crack" in Auto 3D-<inclusion number> section - plot this flat crack manually. After convertion check the quality of convertion and then depending on the result try to edit crack manually or delete inclusion and build it manually.
...
- When you save oxg file in new release, it saves all information about convertions, you have made with inclusions. So when you open oxg file you may proceed quality control (convertion to flat crack and rolling back) without any problems.
- When you use postprocessing options (like allocation with more sensitive threshold), remember that all information about possible convertions of inclusions (plotted by default algorithm) are lost. So if after launching sensitive algorithm you roll back to default one - you cannot do any convertions with inclusions. This issue will be fixed in future releases.
- After autoplotting progress-bar is not closed automatically (last stage is Postprocessing (stage 2)...), so you have to close it manually when plotted inclusion models appear in Oxygen window.
Photorealistic rendering of flat cracks in diamonds
...