Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

MIC is the radius of the maximum circle that may be inscribed.

Girdle center mass is used as the center of a model.

2. Red curve line calculations

  1. Draw plane parallel to table plane through MIC center: 

  2. In that plane distance from model Girdle center to mass to diamond out-line calculated for all azimuth.

    MIC is drawn in red color
    indicates MIC center
     indicated Girdle center mass (model center)
    Diamond out-line is drown in blue color
  3. Minimum radius from step 2 is selected.
  4. Graphics is drawn as deviation from minimum radius.

3. Black curve line calculations

  1. Model is projected on MIC planeand Girdle center mass are projected on table plane:
    Image RemovedImage Added
  2. Distance from model projected Girdle center to mass to projection out-line calculated for all azimuth.

    MIC is drawn in red color
    indicates MIC center
     indicated Girdle center mass (model center)
    Projection out-line is drown in black color
  3. Graphics is drawn as deviation from minimum radius from chapter 2 step 3

...

  • If you have any question, please ask it in comments or send e-mail to developer.
  • If you find mistake, please describe it in comments or send e-mail to developer.
  • If you use report.dll 2.6.5.1 or later MIC will center instead of Girdle center mass will be used for distance calculations as model center.