...

1. Draw plane parallel to table plane through MIC center: 
   
   
2. In that plane distance from model center to diamond out-line calculated for all azimuth.
   

   

   	MIC is drawn in red color
   	indicates MIC center
   	indicated Girdle center mass (model center)
   	Diamond out-line is drown in blue color

3. Minimum radius from step 2 (this section) is selected.
4. Graphics is drawn as deviation from minimum radius.

...

1. Model is projected on MIC plane:
   

2. Distance from model center to projection out-line calculated for all azimuth.

   Image Removed

   Image Added

   Image Added	MIC is drawn in red color
   Image Added	indicates MIC center
   Image Added	indicated Girdle center mass (model center)
   Image Added	Projection out-line is drown in black color

3. Graphics is drawn as deviation from minimum radius from section chapter 2 step 3

4. Notes

• If you have any question, please ask it in comments or send e-mail to developer.
• If you find mistake, please describe it in comments or send e-mail to developer.
• If you use report.dll 2.6.5.1 or later MIC will be used as model center.