Version is available at: Dropbox\Download\DM-Xray\dm-xray-setup-ver-1.0.0.1-alpha39x64-prot-signed.exe

What's new?

Stage for possible cavity approvement

After automatical detection of windows, their manual corrections and approval, you will see a new stage:

You will see a polygonal Xray model with yellow zones - these are all the candidates of cavities with depth from 0.5 to 3 voxels. 

On the top you can see the activated instrument for selection and sorting cavities to approved (green color) and rejected (blue color):

To see cavities under yellow highlighting you may uncheck this check-box (to see them again, check it again):

Instrument for selecting and sorting cavities to approved and rejected

Using this instrument you may:

Here is a short video demonstration of working with the instrument:

Futher stages

If you finished sorting possible cavities, press on 'Proceed' button .

If there were some yellow zones remaining you will see such message:

By clicking on 'Approve all' all remaining yellow zones are moved to 'approved' class and we proceed to the next stages.

By clicking on 'Reject all' all remaining yellow zones are moved to 'rejected' class and we proceed to the next stages.

To cancel moving to the next stage, press 'Cancel'.

Futher stages are similar to alpha 38. As the result you can build small cavities, here you can see the cavity that could not be built in alpha 38 for general and convex simplification:

GeneralConvex (alpha 39)