Description
When you try to add allocation forms to some cut, you cannot do it and get the message:
Or (for already normalized forms):
Possible reasons
Cuts, not belonging to the "Base Cuts" category, usually have a limited set of parameters. For some of them, the Goodwind cut engine is applied which extends the set of parameters - adds slopes. Thus, you can control more parameters for these cuts.
There are some limitations to such cuts:
- Goodwin only accepts when 3 facets with 4+ vertexes converge at one vertex - more than 3 facets of such type are not accepted.
Note Facets with 3 vertexes do not cause limitations.
- Facet types should be correct.
How to solve
- To solve the 4+ vertexes problem, try running Smart Normalize. If this does not help:
- Check facet types of your model.
Example
Here is an example:
|
- A - before Smart Normalize
- B - after Smart Normilize
- Yellow facets have 4 vertexes
- Red facets have: 4 vertexes before SN, 3 vertexes after SN
Thus: - before SN, at the center vertex, 4 facets with 4+ vertexes converge - not good for Goodwin
- after SN, at the center vertex, 2 facets with 4+ vertexes converge - good for Goodwin
|