What's new

• Fixed 'out-of-memory' problem while saving oxg file
• Fixed automatic glue detection / voxel QC crash for non-tringulated immersion cube models
• Fixed autoplotting algorithm (enabled preprocessing and 'unexpected error' for some GPUs)
• Other minor fixes 
• Support of voxel QC tools on not less then 2 Gb video card (in so called 'demo resolution')
• Autoplotting and voxel QC settings in Oxygen GUI
  
  

Autoplotting and voxel QC settings in Oxygen GUI

In this version of Oxygen HIG we added a settings dialog where you may tune autoplotting and voxel QC tools. To launch the dialog click on the settings icon nead 'Find inclusions automatically' button:

After click you will see the dialog:

At the moment you may tune two settings for autoplotting and one for voxel QC tools. These settings are stored in Windows registry and all the applied settings will be the same for all futher program launches (even after Windows reboot). So before every launch of autoplotting or voxel QC, please, check the currently used settings.

Settings for autoplotting:

• Crack autoplotting. If this checkbox is not checked, then the following autoplotting will skip the crack autoplotting procedure. By default we recommend to check this checkbox. You may uncheck it in case when you see that there are too many big inclusions or there are no any cracks in rough. In these cases the probability of good crack processing is small, and the total autoplotting time increases if you enable crack autoplotting. In case of big inclusions these cracks might be combined with other big inclusions - crack autoplotting works well only in case of isolated flat cracks. So it would be better to isolate this crack from big inclusions on voxel QC stage. As for 'no cracks' case, all the time of crack detection will be wasted.
• Automatic glue detection