Hardware configuration storage logic has changed.
The camera-related details which were previously stored together with other parameters at HPODrivers.ini
have been moved to hws.xml
.
The update of the configuration files will occur automatically on the first launch of the program. At that, the following popup message will appear:
SmartRecut algorithm is improved, which has led to a considerable speed up in case of stones with cavities.
Sample Base 1 (no cavities):
SmartRecut Version | Avg. Time, sec |
---|---|
1.10.4.2 | 31.42 |
1.10.4.26 | 32.21 |
Sample Base 2 (with cavities):
SmartRecut Version | Avg. Time, sec |
---|---|
1.10.4.2 | 50.59 |
1.10.4.26 | 40.37 |
Computer configuration:
|
Smart Recut may now be applied to any of the multiple models inside of a Rough stone , in order to improve that model while respecting the borders of other models.
See the example below: two Round brilliants are allocated in a rough stone using Cascade 2M algorithm in Pacor Client. Then the model is imported to HPOxygen, and the larger solution is used as a starting point for Smart Recut. Note that the Smart Recut solution is bigger than the original, yet still fits in the rough stone and remains outside of the other allocated brilliant.
Before Smart Recut | After Smart Recut | |
---|---|---|
The models with multiple brilliants allocated inside a rough stone can't be produced by HPOxygen, and have to be imported from elsewhere. |
New appraisers are added:
Note that both these new appraisers are intended only for appraisal, and not for optimization. |
The users with access to Facetware optimization feature may use another GIA-based appraiser with tightened limits GIA Facetware (Safe) which allows optimization.
Before refinement | After refinement (high precision) | After refinement (low precision) | ||
---|---|---|---|---|
Note the light-green added edge. | Note the refined model (cyan contours) laid over the original model (dark-green contours with light-green added edge). |
Note that in both cases the refinement still can affect multiple other edges, not necessarily limited to the affected facet. |
Refinement of crown and pavilion against Reflect data is now controlled by different buttons and may be run separately.
The buttons are located at the lower part of the Scan panel, and only visible when the panel is set to Advanced mode.
Before refinement | After crown refinement | After pavilion refinement | |
---|---|---|---|
Previously both buttons initiated refinement against all Reflect data |
Exporting model is added to the context menu, both for the scans and recut solutions.
For scans | For solutions |
---|---|
Upon pressing, you will be prompted to specify file name, location, format (type), and basis. The possible export formats are:
The possible basis options are:
Previously the Export model option was accessible via the Export model button on the right panel. |
GIRDLE_INTERNAL_ANGLE_DEG_1
and other similar parameters in Export report data for Princess cut is fixed.CORRECTED_MASS_2
and CORRECTED_MASS_4
, respectively) is now correctly passed on to the I3D Polish reports and I3D Comparative reports..545
" instead of "0.545
"; previously this was not interpreted correctly).