Table Edge Junctions are now calculated for all cutting types. Corresponding bookmarks were implemented and added to report templates:
RBC | Oval | Marquise |
---|---|---|
|
Improved facet type detection on RBC.
Oval Sweetline parameter is added to the SmartRecut Oval presets.
Presently the optimal line is defined as the line with negative slope 1:3 passing through the point with CrownAngle = 36.5 and PavilionAngle = 38.5.
SweetLine is currently not revealed in MyAppraiser and can be managed only via presets. There default value of Oval SweetLine in presets is 3.5°. This value determines zone/stripe by PavilionAngle, upper and lower edges of this zone/stripe pass in 3.5° by PavilionAngle from sweetline as shown on graphics above. i.e. zone is stripe with "width" of 7 degrees by PavilionAngle. Green frame "EX" shows current intervals of MyOval appraiser of EX group for Crown Angle (from 31° to 40°) and Pavilion angle (from 37.5° to 40.5°) which are set by operator in AppraiserEditor panel.
Sweetline value can be decreased to smaller value to get final solutions with CrownAngle/PavilionAngle more close to Optimal Line. For example, if operator decrease sweetline value to 1.75° (zone is shown on picture below) then final solutions will contain CrownAngle and PavilionAngle values in the limits of zone Sweetline 1.75°, more close to optimal line than default value 3.5°. This "tightening" results in better optical performance but could results in worse weight of plan diamond also. Operator can adjust sweetline value to reach optimal ratio "optical performance/weight of plan diamond.
Manual Acceleration setting GUI is now available:
You can choose acceleration setting from ten options with 1 being the slowest and 10 being the fastest.
For this setting to be available you have to update the HPODrivers.ini file.
06. Semicut (final) algorithm now properly considers model orientation so that Recut solutions are always oriented correctly in relation to the semi-cut stone.
06-Semicut-Final_Sample.oxgz
Previous versions | HPO 3.22.41 |
---|---|