Version is available at: Dropbox (OctoNus)\Download\DM-XRay\dm-xray-setup-ver-1.0.0.1-alpha4x64.exe
In Xray GUI you can find the following setting:
The Xray model might not be well calibrated to HPO model (it may have another relative scale).
To do this you may tune scale multiplier which is the ratio between HPO scale and Xray scale (so the Xray model coordinates are multiplied by this coefficient).
By default scale multiplier is equal to 1.
In previous versions of DM-Xray there was a problem with loading huge voxel cubes (with more than 4 billions of voxels).
Now the loading procedure was optimized - actually we load and show only useful parts of a voxel cube (parts with small absorbtion value are ignored and not loaded).
If the useful part of voxel cube is too huge than you will see the message: "The cube is too big - you may have problems with its visualization (black cube)".
This message means that you will not see the correct visualization of the cube, nevertheless you still can launch model building.
In this version you may cut Xray cavities from HPO model of a diamond. The main idea is to preserve the high accuracy of HPO model in convex parts and add cavities to the model from Xray scan.
After finishing the process you will find the resulting model with cavities in a Services list panel (top left panel). You may save is to STL format using the same algorithm as for simplified Xray model.
NOTE: The functionality of cavity cutting is not well tested yet.
Now accuracy for simplified model is set in voxels and the corresponding accuracy in microns is also shown.
If you simplify the model with accuracy less than 1 voxel size or greater than 3 voxels the information will be given in yellow warning color.