...
In Recut mode, in the Cutting list section, your cutting is marked as the one that does not have facet marking. On mouseover, the following message is displayed: "Cutting does not have Facet Marking. Please, register as new cutting, set Facet Marking during registration."
Possible Reasons
Your cutting does not have Facet Marking.
...
- In the Cutting list, find you cutting and copy its name. Tip: UseShow Allocation forms in solution list >Register as new cutting... then copy from Cutting name and close dialog without finishing.
- Close HP Oxygen.
In your file manager, go to the appropriate folder.
Panel bgColor #E0E0E0 ...\ProgramData\OctoNus Software\CommonData\Cuttings
- Find by previously copied name and then delete one of the following:
- ASC file of an ASCII cutting and related INI.
- Folder with DMC cutting and related data.
- Re-start HP Oxygen. Deleted cutting is not presented in the system anymore.
...
- Your "Cutting A" does not have a facet marking.
- You re-register it, add a facet marking, and name a new copy "Cutting A-v.2".
- Then you delete initial "Cutting A".
- In your previously created HP Oxygen projects, you may have a number of solutions with Cutting = "Cutting A". As cutting with this name is not presented in the system now, the appraisers will not be able to display parameter values and grades for these solutions.
- You may have other reasons to wish to keep the old name.
- To revert to the old name, re-register your "Cutting A-v.2" once again, changing the name back to "Cutting A".
- Then delete "Cutting A-v.2".
Now you have "Cutting A" with the facet marking.