...
In Recut mode, in the Cutting list section, your cutting is marked as the one that does not have facet marking. On mouseover, the following message is displayed: "Cutting does not have Facet Marking. Please, register as new cutting, set Facet Marking during registration."
Possible Reasons
Your cutting does not have Facet Marking.
...
- Recommended: to empty your solution list, click File > New.
- Use the Recut mode.
- In the Cutting list, right-click your cutting and then from the context menu, select Show Allocation forms in solution list. Allocation forms are displayed in the solution list.
- In the solution list, right-click the base form (cutting itself) and then from the context menu, select Register as new cutting... The dialog is Register new cutting dialog is displayed.
- In the Register new cutting dialog, to specify a facet marking, click the corresponding link Open Facet Marking to adjust. The Facet Marking dialog is displayed.
- In the Facet Marking dialog, define a facet marking.
- Click Apply. Now cutting being registered has a facet marking.
- Close the Facet Marking dialog.
- Set your new cutting name. Note that the system does not allow two cuttings with the same names.
- Click Ok.
Your cutting is registered and displayed in the Cutting list, under Client cuttings. Your new cutting has facet marking. - Delete the cutting you started from as described in the sections below.
- If you want to revert your new cutting to the old name, re-register it again with renaming to old name. Details can be found in the sections below.
...
- In the Cutting list, find you cutting and copy its name. Tip: UseShow Allocation forms in solution list >Register as new cutting... then copy from Cutting name and close dialog without finishing.
- Close HP Oxygen.
In your file manager, go to the appropriate folder.
Panel bgColor #E0E0E0 ...\ProgramData\OctoNus Software\CommonData\Cuttings
- Find by previously copied name and then delete one of the following:
- ASC file of an ASCII cutting and related INI.
- Folder with DMC cutting and related data.
Delete it. - Re-start HP Oxygen. Deleted cutting is not presented in the system anymore.
Revert to Old Name
...
As the system does not allow two cuttings with the same names, re-registering + deletion described above creates cutting with the new name. For example:
- Your "Cutting A" does not have a facet marking.
- You re-register it, add a facet marking, and name a new copy "Cutting A-v.2".
- Then you delete initial "Cutting A".
- In your previously created HP Oxygen projects, you may have a number of solutions with Cutting = "Cutting A". As cutting with this name is not presented in the system now, the appraisers will not be able to display parameter values and grades for these solutions.
- You may have other reasons to wish to keep the old name.
- To revert to the old name, re-register your "Cutting A-v.2" once again, changing the name back to "Cutting A".
- Then delete "Cutting A-v.2".
Now you have "Cutting A" with the facet marking.