Versions Compared

Old Version 10

changes.mady.by.user Alexander Filonov

Saved on

compared with

New Version 11

changes.mady.by.user Maxim Bashurov

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
titleOn this page:

Table of Contents
outlinetrue
stylenone

System topology for MBox 2.0, MBox 1.5

Gliffy Diagram
namenetwork topology
pagePin13

Cabling

Ethernet

...

Use UTP Cat5E factory-made cables of appropriate length.

USB

...

Use USB Type A male (PC side) / USB Type B male (device side) cables, approx. 2 meters length.

Картинки по запросу usb type a male to usb type b male cable

Endpoints configuration

EndpointGroup

MicroscopeDrivers.ini

table

Configuration software
Prosilica left adapterPC
 

Open Control Panel\Network and Internet\Network Connections, configure each adapter's TCP/IP V4 properties
Prosilica right adapterPC
 

Devices adapterPC
 

Prosilica left cameraMBox
Device= Photo Microscope
 BeginData
 Version= Prosilica
 Name= Left
 UniqueId= 107085

Run GigEIPConfig, configure IP addresses

Run GigEViewer to find each adapter's UniqueId

Prosilica right cameraMBox
Device= Photo Microscope
 BeginData
 Version= Prosilica
 Name= Right
 UniqueId= 37222
DM_ENG motor boardMBox
Table: Motors
 BeginData
 Version= MBox5Lt 

Download folder dm_eng, edit network.info, lines for IP and Mask , then run configure_network.cmd

DM_LHT light boardLight box
Table: FrontLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.131

For rear light: 

Table: RearLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.151

For diffuse light: 

Table: DiffuseLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.152

Download folder dm_lht, edit network_lt.info, lines for IP and Mask , then run configure_network.cmd

For single board:

line "Address= ..." in MicroscopeDrivers.ini can be safely deleted

For multiple boards:

Every board should be configured separately, with distinct IP, disconnecting another board. Record configured IP address to the "Address= ..." line in the corresponding MicroscopeDrivers.ini table

 

...