...

MIC is the radius of the maximum circle that may be inscribed.

Girdle center mass is used as the center of a model.

2. Red curve line calculations

1. Draw plane parallel to table plane through MIC center: 
   Image RemovedImage Added
   
2. In that plane distance from model Girdle center to mass to diamond out-line calculated for all azimuth.
   

   

   	MIC is drawn in red color
   	indicates MIC center
   	indicated Girdle center mass (model center)
   	Diamond out-line is drown in blue color

3. Minimum radius from step 2 (this section) is selected.
4. Graphics is drawn as deviation from minimum radius.

3. Black curve line calculations

1. Model is projected on MIC planeand Girdle center mass are projected on table plane:
   Image RemovedImage Added

2. Distance from model projected Girdle center to mass to projection out-line calculated for all azimuth.

   Image Removed

   Image Added

   Image Added	MIC is drawn in red color
   Image Added	indicates MIC center
   Image Added	indicated Girdle center mass (model center)
   Image Added	Projection out-line is drown in black color

3. Graphics is drawn as deviation from minimum radius from section chapter 2 step 3

4. Notes

• If you have any question, please ask it in comments or send e-mail to developer.
• If you find mistake, please describe it in comments or send e-mail to developer.
• If you use report.dll 2.6.5.1 or later MIC will center instead of Girdle center mass will be used for distance calculations as model center.