| Тема: Helium Polish version 5.6.73.1, report.dll version 2.6.6.1, BriRecon.dll 1.1.10.1, new templates dd 02.06.2015 |
| От: <alexandrov@octonus.com> |
| Дата: 6/3/2015 2:55 AM |
| Кому: Utpal Mistry <utpal@lexus-com.com>, 'Janak' <janak@lexus-com.com>, 'nilesh' <nilesh@lexus-com.com>, "'Kamal@Lexus-Com. Com'" <kamal@lexus-com.com> |
| Копия: Sergey Savrasov <savrasov@octonus.com>, Sergey Sivovolenko <sivovolenko@octonus.com> |
Dear Nilesh, Utpal, Janak, Kamal,
Please find new version of Helium Polish version 5.6.73.1, report.dll version 2.6.6.1, BriRecon.dll 1.1.10.1 and new report templates here:
Dropbox (OctoNus)\Download\HP\2015_06_02_HeliumPolish_5.6.73.1.zip
In this version we made the following changes:
1. Error with "Width-wise culet shift ratio" and "Length-wise culet shift ratio" calculation is fixed. Shift is calculated for RBC in MAX and MIN diameters directions from now:
2. New report parameter is added - "Girdle center mass":
2.1 It is calculated as girdle center mass and indicated on pictures as doted blue cross:
2.2 "Girdle center mass" is used as girdle center for all offset from now and by default:
2.3 To use old girdle center in offset calculation please check "Girdle center" check box in Report options panel:
2.4 Please pay attention that girdle center (blue cross on pictures same as before) calculation is changed:2.4.1 For Princess, StepCuts, Radiant, SquareRadiant и SquareStepCut cuttings it calculates as cross of symmetry axes (was cross of diagonal axes before).
2.4.2 For Pear cutting it is cross of symmetry axis with width axis .
3. There are changes for AnyCut algorithm calculation. Goal is to improve girdle and crown building for Radiants and Step-Cuts.
4. New report parameters were added - CRN_MAIN_5_EDGE_JUNCTION_:
4.1 "Crown main 5 edge junction" is equal to diameter of minimum circle which includes all 3 nodes at this junction, in case the triangle build on 3 nodes have angles below 90°:
4.2 In case if any of angles of triangle build on 3 nodes is above 90°, "Crown main 5 edge junction" (and circle diameter) is equal to maximum distance between any of the 3 nodes at this junction. Circles are shown in red on pictures in report:
5. New report parameters were added - STAR_EDGE_:
5.1 On picture below six star edges are indicated:
5.2 Percentage value is measured as ratio to diameter.
6. New report parameter is added, roundness is calculated for 22.5° angle from now:
7. All reports templates are updated.
Documentation about report parameters will be created\renewed shortly. Please let me know if you have any questions.
Best Regards,
Yaroslav Alexandrov