Versions Compared

Old Version 8

changes.mady.by.user Alexander Filonov

Saved on

compared with

New Version 9

changes.mady.by.user Alexander Filonov

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

EndpointGroup

MicroscopeDrivers.ini

table

Configuration software
Prosilica left adapterPC Open Control Panel\Network and Internet\Network Connections, configure each adapter's TCP/IP V4 properties
Prosilica right adapterPC 
Devices adapterPC 
Prosilica left cameraMBox
Device= Photo Microscope
 BeginData
 Version= Prosilica
 Name= Left
 UniqueId= 107085

Run GigEIPConfig, configure IP addresses

Run GigEViewer to find each adapter's UniqueId

Prosilica right cameraMBox
Device= Photo Microscope
 BeginData
 Version= Prosilica
 Name= Right
 UniqueId= 37222
DM_ENG motor boardMBox
Table: MBox5axisBoardMotors
 BeginData
 Version= MBox5Lt 

Download folder dm_eng, edit network.info, lines for IP and Mask, then run configure_network.cmd

DM_LHT light boardLight box
Table: MBox48LightBoardFrontLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.131

For second boardrear light: 

Table: MBox48LightBoard2RearLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.151

For diffuse light: 

Table: DiffuseLight
 BeginData
 Version= MBox48Lht
 Address= 192.168.0.152

Download folder dm_lht, edit network_lt.info, lines for IP and Mask, then run configure_network.cmd

For single board:

line "Address= ..." in MicroscopeDrivers.ini can be safely deleted

For multiple boards:

Every board should be configured separately, with distinct IP, disconnecting another board. Record configured IP address to the "Address= ..." line in the corresponding MicroscopeDrivers.ini table

...