You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

System topology

network topology

Cabling

Ethernet:

Use UTP Cat5E factory-made cables of appropriate length.

USB:

Use USB Type A male (PC side) / USB Type B male (device side) cables, approx. 2 meters length.

Картинки по запросу usb type a male to usb type b male cable

Endpoints configuration

EndpointGroup

MicroscopeDrivers.ini

table

Configuration software
Prosilica left adapterPC Open Control Panel\Network and Internet\Network Connections, configure each adapter's TCP/IP V4 properties
Prosilica right adapterPC 
Devices adapterPC 
Prosilica left cameraMBox
Device= Photo Microscope
BeginData
Version= Prosilica
Name= Left
UniqueId= 107085

Run GigEIPConfig, configure IP addresses

Run GigEViewer to find each adapter's UniqueId

Prosilica right cameraMBox
Device= Photo Microscope
BeginData
Version= Prosilica
Name= Right
UniqueId= 37222
DM_ENG motor boardMBox
Table: Motors
BeginData
Version= MBox5Lt 

Download folder dm_eng, edit network.info, lines for IP and Mask, then run configure_network.cmd

DM_LHT light boardLight box
Table: FrontLight
BeginData
Version= MBox48Lht
Address= 192.168.0.131

For rear light: 

Table: RearLight
BeginData
Version= MBox48Lht
Address= 192.168.0.151

For diffuse light: 

Table: DiffuseLight
BeginData
Version= MBox48Lht
Address= 192.168.0.152

Download folder dm_lht, edit network_lt.info, lines for IP and Mask, then run configure_network.cmd

For single board:

line "Address= ..." in MicroscopeDrivers.ini can be safely deleted

For multiple boards:

Every board should be configured separately, with distinct IP, disconnecting another board. Record configured IP address to the "Address= ..." line in the corresponding MicroscopeDrivers.ini table

 

 

  • No labels