Versions Compared

Old Version 2

changes.mady.by.user Maxim Bashurov

Saved on

compared with

New Version 3

changes.mady.by.user Maxim Bashurov

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Gliffy Diagram
namemain workflow v.2
pagePin1
Galahad Compass has an intuitive interface with a lot of features helping users to solve everyday tasks.

...

  1. DOP selection and mode.
  2. Showing slope and azimuth direction.
  3. The progress slider for the currently selected step.
  4. The full information about the currently selected step.
  5. The " Table of target is inclined " warning is displayed as a  sign. On mouse over, the detailed tooltip is displayed.
  6. Tree of stages and steps of polishing.

Main controls

Image Removed

The current status indicator provides information about the current workflow step.

Image Added

Slope start "O----" and slope end "----->>" buttons - for selecting slope direction. "Auto" checkbox - allows registering slope direction automatically when the current angle value exceeds some threshold level.

Corresponding "Clear" buttons - for clearing slope start and end points, in case they were set with an error. Also, the "Clear" button for slope zero should be used when the previous facet was finished, and the operator changing to the next facet.

Target slope/azimuth indicator.

"Ready to polish" button - to signal that facet alignment is finished

The current status indicator provides information about the current workflow step.

Target slope/azimuth indicator.


Usage

Gliffy Diagram
namemain workflow
pagePin1
v.2

The main controls should be used as follows:

  1. Set facet zero position
  2. (optional) Set facet slope - if "Auto" mark is active, the slope will be fixed automatically as long as a deflection from zero point exceeds threshold level (usually 1.5 degrees)
  3. (optional) Set facet azimuth - if "Auto" mark is active, the azimuth will be fixed automatically
  4. Indicate that current facet is set to target position and ready to be polished
  5. After switching to the next faceting step, clear previous facet zero positionCheck polished facet and proceed to next step

DOP Calibration

The tab contains controls for DOP calibration. Several DOPs can be calibrated and saved here. Detailed information is presented on the Compass DOP Calibration page.

...