Here you can find information about what is new in Helium Rough/Pacor Client 7.3.3.
Tip |
---|
This version is available for download from the Octonus official web site. |
Panel | ||||||
---|---|---|---|---|---|---|
| ||||||
|
...
The lines used for culet form marking now can be extended up to the girdle. To switch to the mode with extended lines, set Line to "Wide culet form":
Old Mode | New Mode |
---|---|
Note that the old "Culet form" mode also stays available.
...
There were anomalies in the culet form lines - now the problem causing these problems was fixed.
Expand title Show problem examples...
- Building models did not work correctly for polished diamonds - now this problem is fixed.
- Inclusions saved in a Helium Rough/Pacor Client project (OX2Z) were incorrectly editable when opening in other software (MBox, HP Carbon) - now this problem is fixed, inclusions are not editable which is the right behavior.
- Inclusions actually outside the allocated diamond were mistakingly visualized as located inside the model - now this problem is fixed.
- Boundary planes were not imported from the earlier models during Recognition - now this problem is fixed.
- Sandwich inclusions saved in a Helium Rough/Pacor Client project (OX2Z) were not displayed in HP Carbon - now this problem is fixed.
- Laser mapping slowdown in 7.2.X comparing to 6.0.X was fixed.
- Not working Find Next Diamond operation is fixed.