Report orientation

Trapezoid model is orientated in report basis in such way that symmetry axis is vertical and most wide width side is located on top (but not obligatory horizontal):

Length and width measurement

Length is measurement as local diameter minimum parallel to axis symmetry direction (+\-10 degrees). Width is measurement as local diameter  maximum perpendicular to axis symmetry direction (+\-5 degrees):


Girdle width \ length and culet length

  • Girdle side width - widths of narrow Girdle facets
  • Girdle side length - lengths of long Girdle facets
  • Girdle side width-based length -  lengths of Girdle side along the normal to the largest Girdle side width
  • Culet length - Culet length on the projection into the girdle plane

The parameters output into report with the follow bookmark names:

  1. Girdle side width 1 - GIRDLE_SIDE_WIDTH_MM_1
  2. Girdle side width 2 - GIRDLE_SIDE_WIDTH_MM_2
  3. Girdle side width 1 - GIRDLE_SIDE_WIDTH_PC_1
  4. Girdle side width 2 - GIRDLE_SIDE_WIDTH_PC_2
  5. Girdle side length 1 - GIRDLE_SIDE_LENGTH_MM_1
  6. Girdle side length 2 - GIRDLE_SIDE_LENGTH_MM_2
  7. Girdle side length 1 - GIRDLE_SIDE_LENGTH_PC_1
  8. Girdle side length 2 - GIRDLE_SIDE_LENGTH_PC_2
  9. Girdle side width-based length 1 - GIRDLE_SIDE_WIDTH_BASED_LENGTH_MM_1
  10. Girdle side width-based length 2 - GIRDLE_SIDE_WIDTH_BASED_LENGTH_MM_2
  11. Girdle side width-based length 1 - GIRDLE_SIDE_WIDTH_BASED_LENGTH_PC_1
  12. Girdle side width-based length 2 - GIRDLE_SIDE_WIDTH_BASED_LENGTH_PC_2
  13. Culet length - CULET_LENGTH_MM
  14. Culet length - CULET_LENGTH_WISE_PC
  • No labels
Write a comment...