To use DM software without regular MBox hardware, you'll need to update MicroscopeDrivers.ini in DM distribution.
Providing you have working DM setup with MBox hardware.
Update MicroscopeDrivers.ini for this config. Set BoardCount to 0. Comment or delete all BoardX values in the list. Also delete all "Value" entries in the list below "Board" values.
An example of this below:
;Microscope Full driver Device= Engine Microscope Table: Main BeginData Loglevel= Debug Version= Union BoardCount= 0
PowerManagement= on
EndData
End
EndDevice
Related articles