G1 Galahad mode allows visualizing of virtual steps of the cutting process of stone. G1 Galahad mode helps cutter to cut facets correctly by visual control of facet shape and difference values of slope, azimuth, the distance between plan and current model.
In the G1 Galahad mode, you generate polishing steps leading from the current scan to the target solution. Each step is responsible for polishing one single facet, steps are ordered and combined into stages. When working in G1 Galahad, you work with steps and stages and their statuses.
The G1 Galahad mode in HP Carbon is a functionality shared with the Galahad Compass product, thus the information briefly presented in this overview can be explored in detail in the Galahad Compass documentation, specifically, in the release notes. |
For each step, there is a slider bar colored and containing additional numeric data:
Dragging the pointer on a slider bar leads to the changes in the Scene: it displays how the facet will look "at the selected moment".
About 4 colors:
You can right-click at any position of the slider bar and then mark the actual cut in accordance with your stone's current state.
This will lead to:
If your actual cut is within yellow or red, the step will be marked as "Completed" (grey steps). | |
If your actual cut is within a grey area, you need to continue polishing - the green area will show how many µm you need to cut to reach the left of allowed yellow. |
Order of work
An important principle is the order of work. and related statuses of steps and stages:
Unfinished steps
Let us say, you did not finish polishing the step, but want to move to another facet and polish it now. Let us consider an example:
Here you did not finish work on the facet #113 (now step 3 - "In Work", but decided to Start work on the facet #116. | |
So the system follows your decision: work on the facet #116 is now your step "In Work" and you can start working on it. But pay your attention to what happened with #113 - it was split by the Actual Cut mark into what had already been done (now it is "Completed" step 3) and what is still remains to be done: step 9 at the end of the sequence - the work on #113 should be finished there. |
Unfinished stages
The same approach is now used for stages. To finish stage that has unfinished steps, in the list, right-click the stage and then from the contextual menu, select Finish Stage .
This will split the stage into two - one "Completed" (with all steps that have already been completed), and another "Not Started" - at the end of the sequence, with all steps to be completed.
Actual cut model
The " Compass/GPS Actual cut" model is displayed in the solution list. This model is updated each time an actual cut is changed on the faceting step in work. I3D mini and Comparative I3D reports can be built for this model.
You can perform different operations related to stages and steps.
To generate the next faceting stage for the selected solution:
G1 mode shows the main scan and active solution (target plan) from Recut mode:
"G1 Galahad" mode | "Recut" mode |
---|---|
To delete the stage:
You can delete the last sub-step of the step. To do so:
In the confirmation dialog, click OK. The last sub-step of the current step is deleted.
In Galahad Mode, for the selected step it is now possible to manually select the initial facet different from the one automatically calculated by the system. Once manually set, the initial facet can then at any moment be reset to the default one.
It is now possible to edit the Allowance defined during stage generation. The Allowance can be edited both for stages and for separate steps.
To edit allowance for a step:
If you have a modified allowance for the step, you can Discard this difference and revert this step to the stage standard value.
Allowance can also be edited for the stage. Note that if some steps of the stage have their own changed allowance, applying a new value for the stage will reset all steps, the corresponding warning is displayed: